Editing Pivot System (section)

=====[[KnifeDogs Pivot Lap]]=====

The KnifeDogs pivot lap includes one puck, multiple adapters and multiple plungers. Every plunger fits exactly one adapter perfectly. 

To begin, you first need to figure out which adapter fits your bushing. Start by try placing your bushing insde one of the the adapters. If the adapter hole is too small, try one one with a larger hole. If the bushing is loose inisde the adapter, pick an adapter with a smaller hole. If your bushing fits perfectly inside the adapter with little to no wiggle, you have the correct adapter. Next, you need to find the correct plunger. Use the same process as before, but instead but instead of putting the bushing into the adapter, you need to try putting the plunger into the adapter.

After you have found the correct adapter and plunger, place the puck on worn out 600-800 grit sand paper with the logo/text "KNIFEDOGS PIVOT LAP" facing toward you. It is very important that your sandpaper is already very worn out, as wearing the sandpaper out will create a much more even surface which will make producing even bushings much easier. Insert the adapter into the puck and place your bushing inside the adapter with the side that you want to sand, facing downward. Next, insert the plunger into the adapter so it sits on top of the bushing.

After that, press down on the plunger very lightly and on the puck very firmly and move the entire assembly in circles or figure eights across your lapping surface. The lighter you press down on the plunger and the more pressure you put on the puck, the more even your bushing will be. When you have just purchased the pivot lap, the adapter will have a small lip that will hold the bushing inside the adapter. This lip will gradually wear down with use, so be careful not to drop or lose the bushing when lifting up the pivot lap. After you have done a couple of circles or figure-eights, [[#Strop]] the bushing.

 Do not strop your bushing with the pivot lap as this will damage the strop. Always strop the bushing by hand with the stropping technique described near the end in the [[#By Hand]] chapter.

After that, you should check if your bushing is uneven and make it even again as described here: [[#Uneven_Bushing]].

Check the tolerances as described in this chapter: [[#Checking_Tolerances|Checking Tolerances]] and repeat as needed.