Editing MachineWise Slift V2 (section)

==Description==

In its closed position, it is 14,8cm long.

In its open position, it is 26,2cm long.

Without the weights installed, it is 114g

====Handle====

=====Handle Design=====

The Slift V2 uses a [[Construction#Channel]] design, with [[Pin_System#Press-fit]] zen pins. 

=====Handle Dimension=====

Most Slift V2 have a [[Speed_Channel|speed channel]]. The faces have three chamfered cutouts which get increasingly wider and longer towards the end of the handle. The shortest cutout is 3.3cm long and 5,0-5,8mm wide. The middle cutout is 3,41cm long and 6-6.8mm wide. The last cutout located near the end of the handles is 3,5cm long and 6.9-7,7mm wide

The speedchannel has a length of 9.62cm and is 5mm wide all across.

The handles have a face to face thickness of 12.875mm

The handles are [[Taper|tapered]] and are 9.860mm wide near the pivots and 12.673mm wide near the end.

=====Handle Weight=====

One handle with no weights, but with the zen pin installed, weighs 39g.

====Blade====

Slift V2 either have a S35VN or AEB-L blade steel.

=====Blade Design=====

The Slift V2 features a bowie style blade with a clip point design. The blade has has a recurve, no sharpening choil, plunge grind or any form of sharpening guide. The edge smoothly transitiones into the plunge. The spine of the blade is chamfered and rounded.

=====Blade Dimensions=====

The blade is exactly 13,0cm long and the cutting edge is 10,7cm long.

The blade is around 3.183mm thick near the washer area.

=====Blade Weight=====

The blade, with no hardware installed, weighs 31g.

===Balance===

Without the Hardware, the center of mass is 4cm away from the beginning of the handles. With the hardware installed, it is 4,4cm